Next Steps

With the ActiveControl client and server software installed, you are ready to begin configuring ActiveControl, which can be done via the Windows client software. When you start the Windows client software, choose the SAP Logon system entry for the SAP system that you want to act as the ActiveControl domain controller and then your logon details for that SAP system.

The first time that you start ActiveControl after installing or upgrading, you may be asked to:

• Run the ABAP program /BTI/TE_RCRUN in the ActiveControl domain controller. This may be required to perform necessary internal initialisation and conversion steps. If the client software does not ask you to run this program then this step is not necessary.

• Enter a license key for the ActiveControl domain controller. The license key is determined using the system ID and installation number of the SAP system acting as the Transport Expresso domain controller. A license key is not required for the other participating SAP systems, or for the individual installations of the client software. Please contact Basis Technologies with these details (as shown by the client software) if you need a license key.

The ActiveControl configuration can only be changed by a designated ActiveControl Administrator. The first person to logon to ActiveControl following its installation is automatically defined as an administrator. The list of administrators can be changed afterwards if necessary.

Please refer to the following section “Configuring ActiveControl” for further details.