Inbound / Outbound IDocs

!This linkage type is used for validating that the same IDoc was also generated in the playback system for the same script/step. There are two failure reasons (1) IDoc missing or (2) IDoc is different.

Linkage Type - Inbound / Outbound IDoc

There are two failure reasons for inbound and outbound IDocs:

1. IDoc Missing – this failure reason means that when the expected IDoc was validated, a corresponding IDoc from the playback was not found
2. IDoc is Different – the corresponding IDoc from the playback was found, but when the control record or the IDoc segment data was compared, they were found to be different

*Each IDoc that is captured in the recording is compared with the IDoc’s that were captured in the playback. The result of this comparison is shown in the lower left linkage list. A green indicator shows that the comparison was the same. If it is red it means the validation failed.

Additional information is available in the Key Enhancements for Testimony v2.21 on IDOC Deep Validation